Beijing RichAuto S&T Co., Ltd.
70
device.
3)
The power chip of the handle is ageing. This phenomenon also appears when the handle is
powered through the USB cable to the computer. Please return back the handle to our
company.
4)
Temporary solution. Using standard 5V mobile phone charger, supply power through the
USB cable to handle. Duplicate power supply for temporary emergency use.
2. Failed to set work piece origin during normal operation process
1)
It is under the mechanical coordinate system. Check if the main interface displays AX AY AZ,
if yes, should press "
" + "
" switching to work coordinate system. Then it can
set work origin. Press "
" + "
" is for going to mechanical coordinate system
where cannot set work origin in there.
2)
The buttons are broken. Go to “SYSTEM SETUP”-“Buttons Check” menu to check whether
the buttons are normal or not.
3. Assertion error
Assertion error (occurred during the processing or after starting) is generally a software
problem. User can boot the controller by entering “emergency state”, or re-upgrade it. If can’t be
solved either, user should send back it for repairing.
4. Unable to read U flash disk or read error occurs
1)
Processing by U-disk, screen shows “there is no item in this option”. Format U-disk to FAT32,
change allocation unit to the default configuration size. Then re-import processing files, it
will read normally.
2)
U flash disk capacity is too large (16G, 32G or 64G etc.). Recommend replace U disks such as
2G
、
4G
、
8G.
3)
There is something wrong with USB communicate port or U-disk interface is broken
，
change
a new USB port or U-disk.
4)
There is no any reaction while insert into the U-disk. Change a genuine brand of U-disk, such
