Richenpower Y25 AG Drone
User Manual
©
2022 Richenpower Copy Right
17
1 Flight mode/ stop switch
During Route or A-B Route operation, switch Flight mode can stop the current operation.
The aircraft hovers in place and records a Breakpoint. The pilot can operate the aircraft
manually. The Breakpoint shows as a red dot on App. Tap
Route on App to
resume the operation from returning to the breakpoint. Tap Resume at right side of screen
to continue the operation, the Route or A-B Route will continue. Select one Executing tag
from three Resume Operation Route (1. Returning to the breakpoint, 2. Returning to a
perpendicular line, or 3. Go to the next route line).
Switch during Returning home, the
hovers in place. The pilot can operate the aircraft manually.
The current flight mode is displayed on the upper left corner of App.
2 Spray Rate
Monitor and adjust the current spray rate* through the App.
*Spray rate may vary according to the nozzle model and viscosity of the liquid.
3 Spray Button
I
n Position Retention Mode or on the ground, press to start or stop spraying. Note: ‘spray
rate with speed’ must be off in App when you need the aircraft hover and spray.
4 A/B Switch
In Position Retention Mode, switch to the right to record Point A and to the left to record
Point B. The point A and B will be displayed on App.
Return (RTH) Button
Press the Return (RTH) Button on remote controller to bring the aircraft back to the last
recorded home point. The LED of the RTH button is on during RTH. Users can control the
aircraft during the RTH. Press the button again to cancel RTH and regain control of the
aircraft.