GTR055 Electric Lock Manual
Rev 1
5
How to reset the programming password to the default value (123456):
Open the back cover of the wired keypad, you'll find a jumper on the PCB. Change the jumper to 2-3 position
and then power on the keypad. After two short beeps, put the jumper back to the 1-2 position, the program
password has been reset to factory default value (123456)
NOTE: No card will be deleted after reset. The entry password and the card password could not be
changed after reset.
How to use the keypad to operate the gate opener:
If the keypad has been set to "
Card Or Password
" mode, when the keypad is in standby mode, you can,
1.
Enter the 6 digit entry password and then press the "
#
" button to operate the gate opener OR
2.
Swipe the card which has been learnt by the keypad to operate the gate opener
If the keypad has been set to "
Card + Password
" mode,
when the keypad is in standby mode, you can
swipe the card and then enter 6 digits card password, lastly press and release the "
#
" button to operate
the gate opener.
If the keypad has been set to "
Password
" mode,
when the keypad is in standby mode, you can enter the
6 digit entry password and then press and release the "
#
" button to operate the gate opener.
