GTR099 swing gate opener manual – Revision 22
15
Adjusting the Travel Limit Switch:
The limit switch controls the closed position (stop point) of the gate. Moving the limit switch closer to the hinge
point of the gate (the gate post) will make the gate stop at an earlier point when closing. Moving the limit switch
away from the hinge point will make the gate stop at a later point when closing.
To adjust the limit switch, use a screwdriver to loosen the screw of Limit Switch A, slide to the correct position, and
then tighten the screw again.
Pull to Open Limit Switch Adjustment:
Push to Open Limit Switch Settings:
Please Note:
The swing arm contains an internal thread that may separate if over extended. If
overextended “Click” may be heard, to re-connect push and screw the sliding arm Clockwise until the
arm begins to retract by hand.
