6
LED Light Bulb Replacement
1. Unplug the microscope.
2. Unscrew the single screw in the center of
the bottom of the base plate (image at
right).
3. When opening the base take care as wires
will be connected to the microscope frame
and pulling the frame too far from the base
could disconnect wires.
4. The LED bulb has 2 wires soldered to it
(see below).
5. Unscrew the bulb from its base and remove
the soldered wires. Take note of which
colored wire is next to the “+” and “-”
symbols.
6. Take the new bulb and solder the wires so
they are in a similar position to the “+”
and “-” symbols as the old bulb.
7. Screw the bulb back into place.
8. Replace the base plate and tighten the
screw.
