20 June 2005
SERVICE PROGRAM MODE TABLES
5-71
Service
Tables
Option Setup
Data Overwrite Security (DOS) Setup
5878
Press [Execute] to initialize the Data Overwrite Security option for the copier. For
more, see "1.16 MFP Controller Options" in Section "1. Installation".
Edit Option Setup
5879
This SP is used to install the edit option card.
Plug & Play Maker/Model Name
5907
Selects the brand name and the production name for Windows Plug & Play. This
information is stored in the NVRAM. If the NVRAM is defective, these names
should be registered again.
After selecting, press the “Original Type” key and “#” key at the same time. When
the setting is completed, the beeper sounds five times.
5913
Switchover Permission Time
Print Application Timer
5913 2
Sets the length of time to elapse before allowing another application to take
control of the display when the application currently controlling the display is not
operating because a key has not been pressed.
[3~30/1 s]
5913 102 Print Application Set
This SP prescribes the time interval to expire before the machine shifts to another
application when another application currently holds access control for the
standby mode while there is no key input.
[0~1/
1
/1]
5914*
Application Counter Display
0: Off
, 1: On
5914 1* Printer Counter
5914 2* Copy Counter
Selects whether or not these total counters
are displayed in the UP mode.
Mechanical Counter Detection
0: Not detected,
1
: Detected, 2: Unknown
5915
Confirms that the mechanical counter inside the inner cover is connected.
A3/DLT Counter Display
[0, 1 /
0
/ --] (0: OFF, 1: ON)
5918*
Sets the key press display for the counter key.
This setting has no relation to (SSP) SP5-104 A3/DLT Double Count.
Border Removal Area Switching
[0~1 /
0
/ 1]
5923*
Toggles between two settings that affect the appearance of the pages for border
removal and printed facing pages: (1) Using the original area as the allotted area, or
(2) Using only the copy paper as the allotted area.
0
: Original
1: Paper
