SERVICE PROGRAM MODE TABLES
20 June 2005
5-72
Feed Clutch Start Timing Adjustment,
DFU
5958*
Adjusts the clutch timing to optimize the intervals between fed sheets to reduce
jams in the feed unit.
59581*
Start Timing: Tray 1, 2
[35 ~ 57.5 /
42.5
/ 2.5mm]
DFU
59582*
Start Timing: Tray 3, 4, LCT
35 ~ 57.5 /
42.5
/ 2.5mm]
DFU
59583*
Leading Edge Detection
[19~34 /
26.5
/2.5 mm]
DFU
1st Print Delay Timing
[0~60 /
0
/ 1 s]
5959*
Sets the amount of time the machine waits to project the latent image onto the
drum after the feed/development motor, main motor, and fusing/feed-out motor
switch on.
This setting allows the drum and hot roller to turn freely in order to allow more time
for cleaning toner and carbon that has accumulated on the hot roller strippers.
Changing this can improve image quality but can also slow down the first print
time. Adjust only when necessary.
Large Capacity Exit Mode
0: OFF,
1:
ON
5961*
Selects whether or not all stapled copies are sent to Shift Tray 1 when the Two-
Tray finisher is installed.
8K 16K Paper Mode
0
: Off, 1: On.
Switches on/off the use of 8-kai, and 16-kai China paper sizes.
If ‘Off’, 8-kai, 16-kai paper sizes are not displayed after pressing the selection key.
If ‘On’, 8-kai, 16-kai paper sizes displayed after pressing the selection key. For this
setting to take effect, “2” must be selected for SP5131.
With “2” (Europe) selected for SP5131, the ADF can select 16-kai LEF. With
SP5962 set for “0” (Off), the nearest size is detected as shown below.
Size Loaded
16-kai SEF
6-kai LEF
8-kai SEF
5962*
Size Detected
B5 SEF
B5 LEF
B4 LEF
5963
Power Consumption Reduction Mode
DFU
5967*
Copy Server Set Function
0
: ON, 1: OFF
Enables and disables the document server. This is a security measure that
prevents image data from being left in the temporary area of the HDD. After
changing this setting, you must switch the main switch off and on to enable the
new setting.
Debug Serial Output
DFU
5970
*
Determines whether the debug information is output by the serial port when the
machine is powered on.
[0~1 /
0
/ 1]
0: Disable
1: Enable
