20 June 2005
IMAGE FUSING AND PAPER EXIT
6-97
Detailed
Descriptions
SP Settings for Post-Job Cleaning
The previous description of stripper cleaning with drum rotation after small, medium,
and large print jobs is based on the default settings of SP3905. These settings can
be adjusted.
These are the SP codes that control how cleaning is done at the end of a job.
No. Name
Function
3905 001
Number Rotations
Sets the number of times the 1st Cleaning is
done. Default:
1
3905 002
Number of Pages
Sets the number of pages (accumulative total)
to print before 1st Cleaning is done ("Small
Jobs" on previous page. Default:
5
3905 003
No. addtnl. sheets for 2nd
HR stripper cleaning
Sets the number of pages to print (continuous
print job) before 1st Cleaning is done twice
("Medium Jobs" on previous page). Default:
30
3905 004
No. addtnl. sheets for 3rd
HR stripper cleaning
Sets the number of pages to print (continuous
print job) before 1st Cleaning is done once,
then done again after a 15 sec. interval ("Large
Jobs" on previous page).(Default:
100
3905 005
No. addtnl. sheets for 3rd
HR stripper cleaning
Sets the number of times that the cycle for
SP3905 004 is repeated for "Large Jobs".
Default: 0. If set to "1", for example, the
cleaning sequence is repeated once.
3905 006
Job/HR stripper cleaning
priority setting
This SP determines what happens if a new job
starts while cleaning is in progress. Default: 0
(Off): If a new job starts while cleaning is in
progress, cleaning is canceled so the new job
can start. If you set this SP to "1", a new job
cannot start until cleaning has been completed.
Here are some important points to keep in mind about hot roller stripper cleaning:
•
If the machine switches to any of the energy saver modes (low power mode, etc.)
while cleaning is in progress, the cleaning cycle will not be interrupted.
•
The cleaning cycle is not interrupted by free rotation of the hot roller when the
machine is getting ready to print.
•
Opening the front door, however, while cleaning is in progress will stop a
cleaning cycle.
