20 June 2005
DATA OVERWRITE SECURITY UNIT (B735)
1-71
Installation
1.18 DATA OVERWRITE SECURITY UNIT (B735)
1.18.1 SEAL CHECK AND REMOVAL
CAUTION
Before you start the installation, check the box seals to make sure that they
were not removed after the items were sealed in the box at the factory.
1. Check the box seals [A] on each corner of the box.
•
Make sure that a tape is attached to each corner.
•
The surfaces of the tapes must be blank. If you see “VOID” on the tapes, do
not install the components in the box.
2. If the surfaces of the tapes do not show “VOID”, remove them from the corners
of the box.
3. When you remove each seal, the “VOID” marks [B] can be seen. In this
condition, they cannot be attached to the box again.
B735I901.WMF
B735I903.WMF
[B]
[A]
