Monitoring and Configuring the Printer
196
• The “Port” specifies the port number of the direct printing port.
• The “bidirect” setting indicates whether the direct printing port is bidirec-
tional or not.
❖
Setting timeout
msh> diprint timeout [30~65535]
• You can specify the timeout interval to use when the printer is expecting
data from the network.
• The default is 300 seconds.
❖
Setting bidirect
msh> diprint bidirect {on | off}
• You can specify whether the direct printing port is bidrectional or not.
dns
Use the “dns” command to configure or display DNS (Domain Name System)
settings.
❖
View settings
The following command displays current DNS settings:
msh> dns
❖
DNS server configuration
The following command enables or disables the DNS server address:
msh> dns “number” server “server address”
The following command displays a configuration using the IP address
192.168.15.16 on a DNS 1 server:
msh> dns 1 server 192.168.15.16
• You can register up to three DNS server numbers.
• You cannot use “255.255.255.255” as the DNS server address.
❖
Dynamic DNS function setting
msh> dns “interface_name” ddns {on|off}
• You can set the dynamic DNS function “active” or “inactive”.
• {on} means “active” and {off} means “inactive”.
• ip1394 can be specified only when the IEEE 1394 interface is installed.
• wlan can be specified only when the IEEE 802.11b interface is installed.
Interface name
Interface configured
ether
Ethernet interface
ip1394
IEEE 1394 interface
