Facsimile Features
118
4
Programming Changing and Deleting a
Scan Size
This section describes how to program, change, and delete a Scan Size.
When you select a scan size to scan a custom size original, two custom sizes are
available (Program Size 1 and Program Size 2). Use these functions to program
a custom size in advance.
To change an existing scan size, just use the same procedure.
Important
❒
When programming or changing a scan size, it is recommended that you
make a record of the new size.
You can program up to two sizes.
Specify a horizontal length from 128 to 1200 mm, or from 5.5 to 47 inches.
A
Press
[
Facsimile Features
]
.
B
Press
[
Administrator Tools
]
.
C
Press
[
Program / Change / Delete Scan Size
]
.
D
Select
[
Program Size 1
]
or
[
Program Size 2
]
.
E
Enter a horizontal size using the number keys.
Each time you press
[
mm
]
or
[
inch
]
, the units switch between “mm" and
“inch". If you enter a length and press
[
mm
]
or
[
inch
]
, the length is converted
automatically according to the unit (fractions are rounded off). For example,
when you enter
{
2
}
,
{
2
}
, and
{
0
}
in millimeters and change to “inch", the
length “8.7 inch" is shown on the display. If you press
[
mm
]
or
[
inch
]
again,
“221 mm" is displayed.
If you make a mistake, press
[
Clear
]
or the
{
Clear/Stop
}
key, and then try again.
To cancel a scan size, press
[
Cancel
]
.
Summary of Contents for Aficio IS 2425
