Table A: Demonstration Mode
Rotary
Switch No.
Contents
0
200 dpi scan in book mode
1
400 dpi scan in book mode
2
200 dpi scan in ADF mode *
1
3
400 dpi scan in ADF mode *
1
4
200 dpi scan in ADF mode *
2
5
400 dpi scan in ADF mode *
2
6
ADF free run *
3
7
Not used
8
Not used
9
Not used
*
1
: The motor stops just before the paper is scanned.
*
2
: The motor does not stop before the paper is scanned.
*
3
: The scanner drives the ADF without any documents.
Note: During the demonstration, the LEDs indicate the machine status as usual. But if an er-
ror occurs during the demonstration (e.g. mis-feed, jam, etc.), the scanner stops, and the
LEDs indicate the error condition.
Table B: Component Test Mode
Rotary
Switch No.
Contents
0
All components off
1
Lamp on/off *
1
2
Not used
3
Clutches on/off *
2
4
Not used
5
Not used
6
Not used
7
Not used
8
Not used
9
Not used
*
1
: When the reset switch is pressed to start the test, the lamp turns on and off repeatedly.
*
2
: When the reset switch is pressed to start the test, the following operations are carried out.
Note:
Dip Switch 1 must be off for the component test mode.
Doc. table lift clutch on
Doc. table lift clutch off
Doc. table lift clutch off
Pick-up clutch on
Pick-up clutch on
Pick-up clutch off
Service
T
abl
es
October 9th, 1995
SERVICE LEVEL FUNCTIONS
DIP SWITCH SETTINGS
4-3
