1002 1 1st tray
[–9.0 to 9.0 / 0.0 / 0.1 mm/step] ( Copy
Adjustments Printing/Scanning)
1002 2 2nd tray
1002 3 3rd tray
1002 4 4th tray
1002 5 By-pass
1002 6 Duplex
1003*
Paper Feed Timing
Adjusts the amount of buckle the paper feed clutch applies to the paper after the registration
sensor is activated. A higher setting applies greater buckling.
1003 1 1st tray
[0 to 10 / 5 / 1 mm/step]
1003 2 2nd tray (B276/B277 only)
[0 to 10 / 5 / 1 mm/step]
1003 3 Optional tray
[0 to 10 / 5 / 1 mm/step]
1003 4 By-pass feed
[0 to 10 / 6 / 1 mm/step]
1003 5 Duplex
[0 to 20 / 6 / 1 mm/step]
1007
Display By-pass
1007 1 Display By-pass
Displays the by-pass paper width switch output.
1103*
Fusing Idling
This program decides the action of the Fusing Drive Release Mechanism. When you select
"1," the contact/release control is disabled and the drive power is always transmitted to
the fusing unit. As a result, the machine takes a longer time to warm up the fusing unit. Use
SP 1103 1 if fusing quality is low even when the room temperature is not very low.
1103 1 Fusing Idling
[0 = No / 1 = Yes]
1105*
Fusing Temperature Adjustment
Adjusts the target fusing temperature. "Center" indicates the center of the roller; "End"
indicates the front and rear ends.
3. Appendix: SP Mode Tables
22
3
Summary of Contents for Aficio MP 1600L2
