• Installing consumables and loading paper
• Operating the main power switch
• Removing jammed paper
• Providing precautions on use
• Connecting to computers (such as configuring the port setting)
• Giving a brief outline of the tabs in the drivers
Moving the Machine
• It is dangerous to handle the power cord plug with wet hands. Doing so could result in electric
shock.
• Unplug the power cord from the wall outlet before you move the machine. While moving the
machine, take care that the power cord is not damaged under the machine. Failing to take these
precautions could result in fire or electric shock.
• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling
the cord can damage the power cord. Use of damaged power cords could result in fire or electric
shock.
• The machine weighs approximately 14.5 kg (32.0 lb.). When moving the machine, use the inset
grips on both sides, and lift slowly in pairs. The machine will break or cause injury if dropped.
• Be careful when moving the machine. Take the following precautions:
• Close all covers and trays, including the front cover and by-pass tray.
• If optional paper feed units are attached, remove them from the machine and move them
separately.
• Keep the machine level and carry it carefully, taking care not to jolt or tip it. Rough handling
may cause a malfunction or damage the memory, resulting in loss of stored files.
1.
Be sure to check the following:
The main power switch is turned off.
The power cord is unplugged from the wall outlet.
The interface cable is unplugged from the machine.
Main Machine Installation
23
Summary of Contents for Aficio MP 171
