![background image](http://html1.mh-extra.com/html/ricoh/b383/b383_service-manual_1456499181.webp)
ERROR CODES
28 August, 2000
7-6
Code
Meaning
Suggested Cause/Action
0-87
Control channel started
after unsuccessful primary
channel.
•
The receiving terminal restarted the control
channel because data reception in the primary
channel was not successful.
•
This does not result in an error communication.
0-88
Line was disconnected
because PPR was
transmitted/received 9
(default) times within the
same ECM frame.
•
Try using a lower data rate at the start.
•
Try adjusting the cable equalizer setting.
2-10
The modem cannot enter
tx mode
•
Replace the FCU.
2-11
Only one V.21 connection
flag was received
•
Replace the FCU.
2-12
Modem clock irregularity
•
Replace the FCU.
2-13
Modem initialization error
•
Turn off the machine, then turn it back on.
•
Update the modem ROM.
•
Replace the FCU.
2-20
Abnormal coding/decoding
(cpu not ready)
•
Replace the FCU.
2-23
JBIG compression or
reconstruction error
•
Turn off the machine, then turn it back on.
•
Replace the PMU board if the error is frequent.
2-24
JBIG ASIC error
•
Turn off the machine, then turn it back on.
•
Replace the PMU board if the error is frequent.
2-25
JBIG data reconstruction
error (BIH error)
2-26
JBIG data reconstruction
error (Float marker error)
2-27
JBIG data reconstruction
error (End market error)
2-28
JBIG data reconstruction
error (Timeout)
•
JBIG data error.
•
Check the sender’s JBIG function.
•
Update the FCU ROM.
2-50
The machine reset itself
•
If this is frequent, update the ROM, or replace
the FCU.
3-00
G4 interface board reset
•
Replace the G4 interface board or FCU.
3-10
Disconnection during ISDN
G3 communication
•
Check the other terminal and the ISDN line.
•
The other terminal may have dialed a wrong
number.
3-11
Disconnection during ISDN
G4 communication
•
Check the other terminal and the ISDN line.
3-20
A CSA signal was received
during ISDN G4
communication
•
The operator at the other terminal may have
interrupted the communication.
3-21
A CSA was sent during
ISDN G4 communication,
because the Stop key was
pressed
•
The local operator has interrupted the
communication.
3-30
Mismatched specifications
(rx capability)
•
Check the receive capabilities requested from
the other terminal.