5
5-10
Setting up the E-820 from a Windows Computer
Unlike remote Setup, local Setup does not provide separate settings for enabling and
configuring a protocol. For example, remote Setup has two settings for AppleTalk: one
to enable AppleTalk and the other to set the AppleTalk zone. In local Setup, there is
only the setting for AppleTalk zone. By default, the AppleTalk, IPX/SPX, and TCP/IP
protocols are installed and enabled. You can verify that a protocol is enabled in the
Bindings tab of the Network Control Panel.
T
O
CHANGE
PROTOCOL
SETTINGS
IN
LOCAL
S
ETUP
1.
Click Modify or Advanced next to the setting.
The Windows NT Network Control Panel opens.
2.
Click the Protocols tab.
3.
Select the protocol to modify.
Unless you have installed additional protocols, the choices are AppleTalk, NWLink,
IPX/SPX Compatible Transport, and TCP/IP.
4.
Click Properties, make your selections, and click Apply.
5.
Click OK to close the Properties dialog box.
6.
Click OK to close the Network dialog box.
If you have disabled any of the protocols in this procedure, use the Bindings tab of the
Windows NT Network Control Panel when you are ready to make the protocols
available.