3
3-10
Preparing for E-820 Setup
Ensuring the copier connection
Complete the following steps
before
you configure the E-820 and the workstations that
will print to the E-820. A service technician will have performed some initial
installation.
T
O
PREPARE
FOR
E-820
CONFIGURATION
1.
Print a copier test page to verify the copier is functioning normally.
2.
Turn off the copier and connect the interface cable from the copier to the E-820.
3.
To confirm this connection, turn on the copier and the E-820, and print a Test Page
from the E-820 Control Panel.
To print a Test Page, press the Menu button on the Control Panel to display the
Functions menu. Choose Print Pages, and then choose Test Page.
4.
With both the copier and the E-820 turned off, connect the network cable to the
E-820, as described in
The network should already be installed and operational.
5.
Turn on the copier and then the E-820.
Proceed to E-820 Setup, described in Chapter 4.
Ensuring virus-free operation of the E-820 on a network
The E-820 is prone to computer viruses since it uses Windows NT system
architecture. We highly recommend that a network administrator periodically run an
anti-virus program on the E-820 to ensure network security in your environment.
Scanning a E-820 on a network
A network administrator can scan the E-820 from a Windows computer using
commercially available anti-virus software and the following procedure. (Symantec
Corporation’s Norton Anti-Virus software is used here as an example.)
N
OTE
:
Installation or use of anti-virus software on the E-820 server system is not
permitted.
