Partial Copying
35
3
Partial Copying
The Partial Copy function copies only a part of an original.
You need to enter start and end points in the feed direction of the original .
Note
❒
You cannot use the Partial Copying function when using the Rear Table.
❒
You cannot use the Partial Copying function for originals shorter than
255mm.
❒
If you set the start point within 155 mm of the leading edge of the original, the
copier will regard the leading edge as the start point.
❒
The minimum available space between the start point and the end point is 30
mm.
❒
If you do not set the end point after setting the start point (a), the copier will
regard the trailing edge of the original as the end point (b).
❒
If you set the start point within 40mm of the trailing edge of the original, the
copier will cancel the copying and eject the original.
❒
If you set the end point within 40mm of the trailing edge of the original, the
copier will regard the trailing edge as the end point.
❒
In the Synchro Cutting function, the copier will cut the paper in a length from
the start point to the end point.
❒
When the Partial Copying function is selected, the copier will reset the set-
tings for the trailing edge margin, the leading edge margin in the Synchro
Cutting function, and the Repeated Copying function.
a
b
original
Bypass Table
Preset/Variable Cut Mode
Synchro Cut Mode
FW780multi-eu-F_V4_FM.book Page 35 Tuesday, May 27, 2003 5:59 PM
Summary of Contents for FW740
Page 10: ...viii FW780multi eu F_V4_FM book Page viii Tuesday May 27 2003 5 59 PM...
Page 58: ...Copy Settings 48 3 FW780multi eu F_V4_FM book Page 48 Tuesday May 27 2003 5 59 PM...
Page 72: ...Maintaining Your Copier 62 4 FW780multi eu F_V4_FM book Page 62 Tuesday May 27 2003 5 59 PM...
Page 94: ...84 GB GB B048 8600B MEMO FW780multi eu F_V4_FM book Page 84 Tuesday August 30 2005 4 43 PM...