Copy Settings
34
3
Partial Copying
The Partial Copy function copies only a part of an original.
You need to enter start and end points in the feed direction of the original .
Note
❒
You cannot use the Partial Copying function when using the Rear Table.
❒
You cannot use the Partial Copying function for originals shorter than
255mm.
❒
If you set the start point within 155 mm of the leading edge of the original, the
copier will regard the leading edge as the start point.
❒
The minimum available space between the start point and the end point is 30
mm.
❒
If you do not set the end point after setting the start point (a), the copier will
regard the trailing edge of the original as the end point (b).
❒
If you set the start point within 40mm of the trailing edge of the original, the
copier will cancel the copying and eject the original.
❒
If you set the end point within 40mm of the trailing edge of the original, the
copier will regard the trailing edge as the end point.
❒
In the Synchro Cutting function, the copier will cut the paper in a length from
the start point to the end point.
❒
When the Partial Copying function is selected, the copier will reset the set-
tings for the trailing edge margin, the leading edge margin in the Synchro
Cutting function, and the Repeated Copying function.
A
Hold down the
{{{{
Function Select
}}}}
key for 3 seconds or more.
a
b
original
Bypass Table
Preset/Variable Cut Mode
Synchro Cut Mode
Summary of Contents for FW780
