Maintaining Your Copier
54
4
Changing the Roll Paper Size
Change the size guides on the left and
right of the roll paper holder when
you load different sized paper rolls.
Important
❒
Always follow the instructions be-
low when adjusting the roll paper
holder. Do not force the roll paper
holder by pulling or sliding it
strongly. This could damage the
holder.
Removing the Roll Paper
Holder
A
Push the paper holder inwards,
and then pull it upwards to re-
move it.
Note
❒
The paper holder is attached
with magnet and a hook.
❒
The paper holder is on the right
in this illustration.
Setting the Roll Paper Holder
A
Insert the hook on the paper hold-
er into (
A
A
A
A
), and then insert the
protrusion into (
B
B
B
B
).
Note
❒
Make sure the protrusions are
firmly in the hole.
❒
Lock the lever until it clicks.
B
Match the paper size as same as
one shown in the windows .
Standard paper sizes that can be
used in this copier are shown be-
low.
Summary of Contents for FW780
