7
A
ppendix
144
Playback/Deletion
Problem
Cause
Solution
Page
Shooting information is
not displayed.
Information display is set to [No
Information Display].
Press
j
to switch the information
displayed on the screen.
Dust or dirt particles
appear in images.
The sensor is dirty or dusty.
Perform [Dust Removal] in the
E
9 menu.
The Dust Removal function can be
activated every time the camera is
turned on and off.
—
Pixel defects such as
bright spots and dark
spots appear in the
image.
There are defective pixels in
the sensor.
Perform [Pixel Mapping] in the
E
9 menu.
It takes about 30 seconds to correct
the defective pixels, so be sure to
install a fully charged battery.
—
Images are not
displayed on an AV
device.
The cable is not correctly
connected.
Connect the cable correctly.
The input setting of the AV
device is incorrect.
Check the AV device settings.
—
The images on the
memory card cannot be
played back.
The images are not
displayed on the
monitor.
The inserted memory card is not
formatted with this camera.
Insert a memory card formatted
using [Format] of the
E
1 menu in
this camera.
The memory card contacts
are dirty.
Clean with soft, dry cloth.
—
The card is malfunctioning.
There is no problem with the camera
if images in another memory card
can be played back with this camera.
Do not use a memory card that has
a problem.
—
The monitor turned off. The battery is exhausted.
Charge the battery.
The [Auto Power Off] function
has been activated because the
camera was not operated for a
certain period of time.
Turn the camera back on.
File(s) cannot be
deleted.
[Protect] is set for the image(s). Cancel the protection in [Protect] of
the
C
1 menu.
The memory card is locked.
Unlock the card.
—
The memory card can-
not be formatted.
The memory card is locked.
Unlock the card.
—
Downloaded from
