- 7 -
Image Scanner User's Manual
Installation
Caution:
E
No two devices on the SCSI-chain can have the same ID number.
E
The setting will not take effect until the machine is reset.
E
Do not set the SCSI ID to 8 or 9. The SCSI ID must be set between 0 and 7, even though 8
and 9 are present on the rotary switch.
E
If more than two of this manufacturer’s scanners are connected to your system, you can not
use SCAM. In this case, set the unique IDs for each scanners manually.
This scanner supports the SCAM standard. If
your system also complies with this standard,
set DIP switch 3 to OFF position (original
position). The SCSI ID will be assigned
automatically when power is next turned on. If
your system does not comply with this standard,
follow the steps below to set the ID manually.
1. Set DIP switch 3 to the ON positon.
2. Turn the rotary switch and set the number to
the desired SCSI ID number.
3. If you change the SCSI ID while the scan-
ner is on, reset the scanner by turning the
power off and on, or pushing the reset
switch.
1. Make sure that the power switch is turned
off.
2. First, insert the power cable into the power
cord socket at the rear of the scanner.
3. Insert the other side of the power cord into
the plug receptacle.
¡
Connecting the power cord
Caution:
E
Use the standard cable supplied with this unit. Otherwise, use cables that meet the re-
quirements on page iv.
E
Connect the power cable before turning the power switch on.
E
This product is equipped with a 3-wire grounded power system.
The plug has a grounding pin and must be inserted into a grounded outlet.
¡
Setting the SCSI ID
ON
1 2 3 4 5 6 7 8
03_IS430-BODY
97.5.8, 5:35 PM
Page 7
PageMaker 5.0J
