3.Troubleshooting
26
Code
Meaning
Suggested Cause/Action
73
Receipt, or there is a problem with the firmware.
15-
74
MDN Message ID Error
Could not find the Original Message ID line in the header of
the Return Receipt, or there is a problem with the firmware.
15-
80
Mail Job Task Read Error
Could not receive the transmission because the destination
buffer is full and the destination could not be created (this
error may occur when receiving a transfer request or a
request for notification of reception).
15-
81
Repeated Destination Registration Error
Could not repeat receive the transmission because the
destination buffer is full and the destination could not be
created (this error may occur when receiving a transfer
request or a request for notification of reception).
15-
91
Send Registration Error
Could not receive the file for transfer to the final destination:
The format of the final destination or the transfer
destination is incorrect.
Destinations are full so the final and transfer destinations
could not be created.
15-
92
Memory Overflow
Transmission could not be received because memory
overflowed during the transaction.
15-
93
Memory Access Error
Transaction could not complete due to a malfunction of SAF
memory.
15-
94
Incorrect ID Code
The machine rejected an incoming e-mail for transfer request,
because the ID code in the incoming e-mail did not match the
ID code registered in the machine.
15-
95
Transfer Station Function
The machine rejected an incoming e-mail for transfer
because the transfer function was unavailable.
22-
00
Original length exceeded the maximum
scan length
Divide the original into more than one page.
Check the resolution used for scanning. Lower the scan
resolution if possible.
Add optional page memory.
22-
01
Memory overflow while receiving
Wait for the files in the queue to be sent.
Delete unnecessary files from memory.
Transfer the substitute reception files to an another fax
machine, if the machine’s printer is busy or out of order.
Add an optional SAF memory card or hard disk.
22-
02
Tx or rx job stalled due to line disconnection
at the other end
The job started normally but did not finish normally;
data may or may not have been received fully.
Restart the machine.
Summary of Contents for M0A0
