8.
Device Drivers
When using Windows 98/95 or Window NT Workstation Ver. 4.0, the installation of any special device drivers are not
required.
In order to ensure normal drive operation or if the drive is not recognized by your computer, please check the following:
In order to ensure normal drive operation
If the drive is not recognized by your computer
In order to ensure normal drive operation
For Windows 98/95 Users
●
The drive is displayed in [control panels] - [system] - [device manager] - [CD-ROM]
●
32-bit is displayed in [control panels] - [system] - [performance]
For Windows NT Workstation Ver.4.0 Users
●
The drive is displayed on the IDE controller in [control panels] - [SCSI adapter] -[devices]
If the drive is not recognized by your computer
For Windows 98/95 Users
●
If a [!] indicator is displayed on the IDE controller in [control panels] - [system] -[devices manager]-[harddisk
controler], you will need to contact your PC manufacturer or the motherboard manufac-turer and get the
appropriate IDE controller driver.
For Windows NT Workstation Ver.4.0 Users
●
If a [!] indicator is displayed on the IDE controller in [control panels] - [SCSI adapter] -[devices] , you will need to
contact your PC manufacturer or the motherboard manufacturer and get the appropriate E-IDE controller driver.
|
2. Removing the Computer Cover
4. Connecting the Power Connector
7. Replacing the Computer Cover
| 8. Device Drivers
Summary of Contents for MP7080A
Page 7: ...fig1 1 Check 2 Recording surface fig2 1 50 to 100mm Back ...
Page 20: ...3 Load the disc by pressing the eject button or by lightly pushing in the disc tray ...
Page 21: ...Next Load the disc Disc ejection Emergency Eject Using the Drive in a Vertical Position ...
Page 31: ...To Install as a Slave Drive ...