4.
FU
6
1
9
9
5
then immediately
Y
FUNCTION KPAD/NEXT
SERVICE FUNCTIONS
5.
1
2
Y
0-SRAM 1-SAF
2-SAFCARD 3-M->R
6.
3
S
If the software is successfully uploaded,
the display shows "OK".
OK!!
COPY MACH -> FLROM
If the software upload fails, the display
shows "NG".
NG!!
COPY MACH -> FLROM
7. Finish :
FU
8. Turn off the machine, put back the IC card and covers, and turn on again.
I
CAUTION
If the IC card is missing, the machine will only be able to make partial
copies of each original because of a lack of page memory.
4.1.25. SRAM Data Download (Function 12)
This function copies all the data stored in the SRAM on an external FCE to
the machine’s FCE. Use this after replacing a damaged FCE to save any pre-
vious settings that were programmed in the damaged FCE.
1. Turn off the machine.
2. Connect the Flash/SRAM Copy Tool [A] and the damaged FCE [C] as
shown in section 4.1.22.
Note:
The setting of switch [D] on the tool will not affect the result of
this procedure.
3. Turn on the machine.
4.
FU
6
1
9
9
5
then immediately
Y
FUNCTION KPAD/NEXT
SERVICE FUNCTIONS
5.
1
2
Y
>
0-SRAM 1-SAF
2-SAFCARD 3-M->R
May 22nd, 1995
SERVICE TABLES AND PROCEDURES
SERVICE LEVEL FUNCTIONS
4-15