Chapter 4 -
11
give the whole context, whether typed or typeless, and do not begin your context path
with a trailing period (.). If you don't know your tree, type: whoami at the DOS
command line. A typed context name example is:
ou=standard.ou=organization_1
7.
In the default mode, the Print Server scans each queue which it is to service once per
second. If you prefer a longer scan rate, you may enter the time between scans in
seconds in the Print Queue Scan Rate field.
8.
The Network Interface Board will normally monitor the network to determine which
frame type is being used for Novell.
When it recognizes a type, it will assume the same frame type. Once it selects a frame type, the
Network Interface Board will only operate over that Novell frame type. Monitoring normally starts
looking for IEEE 802.3, then Ethernet II, then 802.3 SNAP, etc. If your network is using multiple
frame types for Novell, you should bias the frame search to the desired type by setting the button
next to the designation under Ethernet Frame Type.
9.
You can Disable Bindery mode on the Print Server if it is operating in NDS mode
only. To do so, click on that box. If you disable Bindery, the Network Interface Board
will not support Print Servers on a Bindery file server.
10.
Once you have selected all desired settings and entered the desired NetWare
information, you may cause this information to be entered in the Network Interface
Board NV RAM by clicking on Accept Settings.
As with all value changes, if you have not entered the Network Interface Board Management
Password before, you must enter it in the appropriate space before clicking on Accept Settings.
11.
Entered values do not take effect until the Network Interface Board is reset or power
cycled. You may reset from MAP or the Web Browser by returning to the Home or
Network Administration page, and click on Reset under System.
Now click on Reset Unit. Alternatively, you may power cycle the printer. The new NetWare values
should now be in effect.
4.5
Using the Novell PCONSOLE Utility
This section explains how to use the PCONSOLE utility to perform the following tasks:
Ÿ
Attach and select a file server
Ÿ
Select or delete queues for the print server
Ÿ
Set-up the Notify function
See the NetWare Print Server Manual for detailed information on this utility.
Note:
You must have Supervisor privileges to perform many PCONSOLE
operations.
4.5.1
Changing the File Server
You can specify a file server as the current one.
To change the file server, use the following procedures:
1.
Log into the current file server and start the PCONSOLE utility.
Summary of Contents for NIB 450-E
