108
Restoring the Setting
Select [0 SEC] in step
e
above.
M E N U [ S E T U P ]
L C D C O N F I R M A T I O N : 1 S E C
L C D S E T T I N G : O N
I N I T I A L I Z E S E T T I N G
P A S S W O R D : O F F
S E Q U E N T I A L F I L E N O : O N
D I S P L A Y P O W E R : O F F
S E L . : E N T E R
M E N U [ S E T U P ]
L C D C O N F I R M A T I O N : 3 S E C
L C D S E T T I N G : O N
I N I T I A L I Z E S E T T I N G
P A S S W O R D : O F F
S E Q U E N T I A L F I L E N O : O N
D I S P L A Y P O W E R : O F F
S E L . : E N T E R
How To Cancel the Setting
Follow the above procedures and select the other video system in step
e
.
Note
• When setting to PAL, this camera cannot be used as a monitor for the
video printer, etc.
• The LCD monitor would appear blank when the video cable is connected
to video gear.
Changing LCD Confirmation
When you press the shutter release button to take a picture, the shot image appears
on the LCD monitor, accompanied by a beep, before it is recorded. You can select the
image confirmation time from among 0 second, 1 second, 2 seconds, and 3 seconds.
q
Set the mode dial to [
].
The SETUP menu will open.
Note
• To cancel the operation, turn the mode
dial.
w
Press the
▼
or
▲
button to select [LCD
CONFIRMATION].
e
Press the ENTER button and select the
image check time (0 sec., 1 sec., 2 sec., 3
sec.).
To end setting, rotate the Mode dial and switch
to another mode.
Note
• Images are not displayed when the
image confirmation time is set to 0 sec.
The images are recorded immediately
after the photograph is taken.
