72
Note
• Moving the camera before the beep sounds, after pressing the shutter
release button, could result in a blurred image.
Note
• S mode works only when the flash is disabled from firing.
• Enable the keep settings to save the S mode setting. See “Keep
Settings” (p.104).
Using Auto Bracket
This function takes three continuous frames: one each at the set exposure and at -
0.5EV and +0.5EV. This feature makes it possible to obtain correct exposure under
difficult conditions.
Mount the camera on a tripod or level surface to prevent the camera from moving.
q
Set the MODE dial to [
] and then press
the MENU button.
The Recording menu will appear.
Note
• Press the MENU button to cancel the
operation.
w
Press the up
▼
or down
▲
button to
turn AUTO BRACKET to ON.
Press the ENTER button to select ON when in
OFF and then press the MENU button.
e
Press the release button to take the
picture.
When the release button is pressed, three
frames will be taken at the set exposure of –
0.5EV, 0, + 0.5EV.
How To Cancel Auto Bracket
Follow the above procedures and select OFF in step
e
.
How To Cancel the S Mode
Follow the above procedures and select [OFF] in step
e
.
S O F T M O D E : O F F
S M O D E : O F F
A U T O B R A C K E T : O N
B A C K : M E N U S E L . : E N T E R
