5-6
Confidential
Transfer to the shipping state
<Function>
This function is to transfer the machine to the shipping state when used new spare main PCB
for repair, etc. When not perform this function to the new spare main PCB and leave, some
software will be unavailable such as MPS applications or BrAdmin tool. Also, the machine
keeps poor state of security such as risk of leaking private information. Do not forget to
perform this function after replacing the new spare main PCB. However, this product does
not have function for place back to the pre-shipping state from the shipping state.
<Operating Procedure>
(1) Press the [
▲
] or [
▼
] in the initial state of maintenance mode to display “MAINTENANCE
03” on the LCD, and press the [OK].
“1.SWSUM?” is displayed on the LCD.
(2) Press the [
▲
] or [
▼
] to select “3.ShippingStat?” and then press the [OK]. “ON” or “OFF:
Change OK?” is displayed on the LCD.
(3) When “ON” is displayed on the LCD, the machine is at shipping state. Press and hold
the [Go] for five seconds to return to the initial state of the maintenance mode.
When “OFF: Change OK?” is displayed on the LCD, press the [OK]. The machine will
transfer to the shipping state and returns to the initial state of the maintenance mode.
Note:
Be careful that if the special function at start up in the preceding item is a valid state
([FUNC ENABLE]), it is unable to transfer the machine to the shipping state.
Be sure to operate after changing to an invalid state ([FUNC DISABLE]).
