However, since the folding strength is high, toner cracking may occur at fold lines. In such a
case, toner cracking at fold lines may be reduced by adjusting the offset amount to 0 mm.
Difference in Alignment and Folding Strength
Difference in Alignment
Folding Strength
Thickness of the
booklet
The amount of toner
sticking to the folding
line
3mm (default)
Strong
Thin
OK
0mm
Weak
Thick
Good
5.
Close the bracket after the adjustment.
6.
Reassemble the machine.
Adjusting the Folding Speed
You can adjust the thickness of the booklet by adjusting the moving speed of the flat fold booklet unit.
If you want to make the booklet thinner, set a slower speed. If you want to make the booklet thicker, set
a faster speed.
1.
Enter the SP mode.
2.
Set the moving speed of the flat fold booklet unit for each paper size with SP6-114-001 to
010 (Fold Speed Adj.: 2K/3K FIN).
SP
Setting Items
Selection
Default Value
SP6-114-001
Fold Speed Adj.: 2K/3K FIN: A3 SEF
0: Standard
*
1: Middle
2: Low
0: Standard
SP6-114-002
Fold Speed Adj.: 2K/3K FIN: B4 SEF
SP6-114-003
Fold Speed Adj.: 2K/3K FIN: A4 SEF
SP6-114-004
Fold Speed Adj.: 2K/3K FIN: B5 SEF
SP6-114-005
Fold Speed Adj.: 2K/3K FIN: DLT SEF
SP6-114-006
Fold Speed Adj.: 2K/3K FIN: LG SEF
SP6-114-007
Fold Speed Adj.: 2K/3K FIN: LT SEF
SP6-114-008
Fold Speed Adj.: 2K/3K FIN: 12"×18"
SP6-114-009
Fold Speed Adj.: 2K/3K FIN: 8K SEF
SP6-114-010
Fold Speed Adj.: 2K/3K FIN: Other
1. Replacement and Adjustment
90
Summary of Contents for SR3160
