191
7
Connect
in
g t
o
a
Com
put
er
7Connecting to a
C
o
m
p
u
t
e
r
Connecting to a Computer
Set the device to which the camera is connected with the USB cable.
1
Turn your camera on.
2
Use the four-way controller (
23
) to select [USB Connection]
in the [
W
Setting] menu.
3
Press the four-way controller (
5
).
A pull-down menu appears.
4
Use the four-way controller (
23
) to select [MSC].
5
Press the
4
button.
The setting is saved.
MSC (Mass Storage Class)
A general-purpose driver program that handles devices connected to the
computer via USB as a memory device. Also indicates a standard for controlling
USB devices with this driver.
By simply connecting a device that supports USB Mass Storage Class, you can
copy, read, and write files from a computer without installing a dedicated driver.
PTP (Picture Transfer Protocol)
A protocol that allows transfer of digital images and control of digital cameras via
USB, standardized as ISO 15740.
You can transfer image data between devices that support PTP without installing
a device driver.
Unless otherwise specified, select MSC when connecting the camera to a
computer.
Setting the USB Connection Mode
Always set the USB Connection mode before connecting the camera to a
computer. You cannot perform the following setting after the camera is
connected to a computer with the USB cable.
MSC and PTP
Summary of Contents for WG-4
Page 207: ...205 8 Appendix a b K c R B c c Q e S 9 38 38 38 4 4 5 6 ...
Page 250: ...Memo ...
