97
3
Taki
ng Pi
ct
ur
es
6
Press the
4
button.
The setting is saved.
The D-Range Setting icon appears on the
display.
By using this function, you can correct camera shake during shooting. You can
select the optical correction only (Sensor Shift) or both the optical and electronic
corrections (Dual). The default setting is [Sensor Shift].
1
Use the four-way controller (
23
) to select [Shake Reduction]
in the [
A
Rec. Mode] menu.
2
Press the four-way controller (
5
).
A pull-down menu appears.
3
Use the four-way controller (
23
) to change the setting.
4
Press the
4
button.
The setting is saved.
P
When [Highlight Correction] is set
to [Auto] or [On]
Q
When [Shadow Correction] is set to
[Auto] or [On]
O
When both [Highlight Correction]
and [Shadow Correction] are set to
[Auto] or [On]
• When [Highlight Correction] is set to [On], the minimum sensitivity value is
doubled.
• If you change the [Highlight Correction] or [Shadow Correction] setting
frequently, you can save time by assigning it to the Green button (p.102).
The D-Range setting cannot be set in some shooting modes. Refer to
“Functions Available for Each Shooting Mode” (p.204) for details.
Setting the Shake Reduction
Sensor Shift
Corrects camera shake optically only.
Dual
Corrects camera shake both optically and electronically.
Off
Does not apply optical or electronic correction.
3 8
3 8
P
Summary of Contents for WG-4
Page 207: ...205 8 Appendix a b K c R B c c Q e S 9 38 38 38 4 4 5 6 ...
Page 250: ...Memo ...
