Ricon 20-600H, Operator'S Manual

ADJUSTMENTS

14

FIG. 18

FENCE ADJUSTMENTS

1. To move the fence across the table, loosen the lock 

lever (A), slide the fence to the desired position on the 

table and then retighten the lock lever. FIG. 18.

NOTE:

 The handle direction of the lock levers (A) and 

(B) can be repositioned by pulling up the lever and re-

positioning it on the nut located underneath the lever.

2. To tilt the fence, loosen the lock lever (B), and tilt 

the fence to the desired angle. Then retighten the lock 

lever. FIG. 18.

3. The fence has adjustable positive stops at the most 

used fence positions of 90 degrees and 135 degrees.

FIG. 19

FIG. 20

FIG. 21

FIG. 18

THE MACHINE MUST NOT BE 

PLUGGED IN AND THE POWER SWITCH MUST BE IN 
THE OFF POSITION UNTIL ALL ADJUSTMENTS ARE 
COMPLETE.

SETTING THE FENCE TO 90° and 135°

To check and adjust the positive stops to the 90 and 

135 degree settings:

4. Put a square on the table with one end against the 

fence and adjust the fence until it is exactly 90 

degrees to the table. FIG. 19.

5. Tighten the set screw (C) with a hex wrench until it 

contacts the stop. FIG. 20.

6. Put a square on the table with one end against 

the fence and adjust the fence until it is exactly 135 

degrees to the table. FIG. 21.

NOTE:

 With the fence set at 135°, the jointer will 

produce a 45° bevel on your workpiece.

7. Tighten set screw (D) with a hex wrench until it 

contacts the stop. FIG. 20.

A

C

B

D

D

135° SETTING

90° SETTING

90° SETTING

135° SETTING