For the most up to date documents, bike models, additional information, instructional videos,
13
3.3 Seat Post Assembly:
•
Open the seat clamp and insert the seat post to or past the minimum insertion point. (Figure 8 & 9)
•
Adjust the suitable height and rotate the clamp to tighten and then shut it. (Figure 10)
3.4 Seat Clamp Assembly:
•
Slide saddle into seat post clamp.
•
Using an 6mm hex wrench. Tighten the bolt to 16-17nm of torque (unless otherwise marked
on the seat post).
•
The seat post angle is adjustable. Make sure the grooves are properly aligned. Ensure the
bolt(s) is correctly torqued.
If left loose or over-tightened, the seat post bolt could snap
causing serious injury and/or death.
8
9
10
