power source, it is recommended to set the value as the rated power of the power
source*95%;
Temperature
unit is
℃
by default, it can be switched between
℃
and
℉
(figure
5);
Battery Charger Sub-menu(figure 6):
CutOff Current
is set to 10mA by default and it can be edited, when the real
output current is lower than this set value, the output will be cut off automatically.
CutOff Temp.
is set to 60
℃
by default, when the external temperature sensor
detect over 60
℃
, the output will be cut off automatically.
Communication Sub-menu(figure 7):
Interface
is set to USB by default, you can also set it to WIFI/TTL/RS485, USB
means the micro USB port, you can see
on the top when set it USB, and when
the communication starts, it will show
; You need to insert a WIFI board to use
the WIFI function, and it will show
on the top, and when the communication
starts, it will show
; TTL is not available now; You need to insert RS485 module to
use RS485, and it will show
on the top, and when the communication starts, it
will show
.
Baudrate
is set to 9600 by default, you can set it to 9600/19200/38400/57600/
115200, under WIFI communication mode the baud rate is 115200 and it cannot be
edited.
Address
is set to 001 by default, you can set it between 1 and 255;
The Baud rate and address on the device should be same with the information
on PC software or APP. You can see more communication at PC software and APP
section.
Date and Time Sub-Menu(figure 8):
Date
and
Time
can be set from 2000 to 2100, press
or
you can select
the option, and use encoder potentiometer can adjust the value, it will be applied
immediately when you change the value, please do not set the wrong time.
figure 9
figure 10
figure 11
1.4.2.6 Main Page Display Style Setting
Main interface display style setting operation video:
https://drive.google.com/drive/folders/1gMkuCZrr_G-PlyHqO-i6fxdS-XRvuOIG?
usp=sharing
You can press
+
to enter the system setting menu, then press
Summary of Contents for RD6006P
Page 33: ......
