声明：本说明书著作权归杭州睿登科技有限公司所有，未经允许任何单位或个人不得用于商业用途。
45
1.4.2
Operation Introduction
In the menu operation, the icon in red or cursor is the currently selected menu,
press
to confirm or enter, press the encoder potentiometer to cancel or return,
press the direction button to move the cursor or switch menu, rotate the encoder
potentiometer to change the setting, the settings will be automatically saved when
returning from the menu page.
Press and hold the 0 button and power on to restore
the factory settings, press and hold the 1 button and power on to restore the factory
calibration value, press and hold
and power on to enter the boot mode.
1.4.2.1 Battery Charging Function Introduction
Battery charging operation video
：
https://drive.google.com/drive/folders/1g8v_l1X9uwRM1P4GPwKhnP4No
After power on,
at battery related information display area, external
temperature, capacity and energy will loop display. When the output is turned on:
capacity, energy will be automatically accumulated, and automatically cleared after
power off.
The green terminal is connected to the positive electrode of the battery, and the
black terminal is connected to the negative electrode of the battery. After the battery
is correctly connected, the battery charging indicator turns red
and the battery is
connected. Press
to start charging, the battery charging indicator turns green
. When the actual output current is lower than cut off current value (
10 mA, can
be set by user
), or the temperature that the external temperature sensor tested is
greater than the cut off temperature value, the output will be cut off automatically.
Battery with protection board needs to be charged with red and black terminals. The
charging voltage and current should be set on your own.
It is strongly recommended to use the original charger to charge the battery. The
charging function of this machine can only serve as a temporary replacement, not for
long-term use. You need to know the battery parameter well so that you can use it to
charge, There is a risk of fire and explosion during the charging process if you use the
wrong way to charge. Common Battery voltage
