9 – English
ASSEMBLY
TOOLS NEEDED
See Figure 2, page 19.
The following tools (not included or drawn to scale) are
needed for assembly:
Adjustable Wrench
Phillips Screwdriver
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
INSTALLING THE HANDLES
See Figure 3, page 20.
Insert supplied handle through handle slot.
Slide handle forward until the hole in the handle is aligned
with the first hole in the handle slot.
Place a washer and lock washer onto long screw. Then
install long screw through the hole in the handle.
Place a washer and lock washer onto short screw. Then
install short screw through the second hole in the handle slot.
Repeat handle installation on the opposite side.
INSTALLING OIL CAP/DIPSTICK
See Figure 4, page 20.
The air compressor has a label installed between the pump
oil cap/dipstick and the oil fill hole. Before using the unit the
first time, remove the pump oilcap/dipstick and label and
then reinsert dipstick. Make sure to add oil before first use.
See
Adding/Checking Pump Oil
before first time operation.
INSTALLING THE SEMI-PNEUMATIC TIRE
See Figure 5, page 20.
Insert supplied axle rod through hole in semi-pneumatic
tire hub, centering the tire between the two center holes
in the axle rod.
Slide hitch pins through both holes on either side of semi-
pneumatic tire to secure semi-pneumatic tire to the center
of the axle rod.
Place tire assembly in the center of the wheel brace as
shown.
Align the threaded holes on the tire assembly with the
holes on the left and right side of the wheel brace. Install
supplied Phillips head screws through the lined up holes.
OPERATION
DANGER:
Do not disassemble pressure unloader, tank drain
valves or safety relief valve with air in tank — bleed
tanks.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Never direct a jet of compressed air toward people
or animals. Take care not to blow dust and dirt
towards yourself or others. Following this rule will
reduce the risk of serious injury.
CAUTION:
Do not use in an environment that is dusty or
otherwise contaminated. Using the air compressor
in this type of environment may cause damage to
the unit.
APPLICATIONS
Air compressors are utilized in a variety of air system
applications. Match hoses, connectors, air tools, and
accessories to the capabilities of the air compressor.
