2
UC-60 Crimp Heads Instructions
there is enough room to evenly space crimps between electrical
connector lines.
Figure 3 – Aligning the Connector in the Crimp Profile
9. With hands clear of the head and other moving parts, operate the
Electrical Tool as per its instructions. After a complete cycle the tool
ram will retract and the jaws will open. If the ram does not retract,
the crimp is not complete and must be repeated.
A slight twist of the connection may be needed to release it from
the crimp profile.
10. If the ram does not fully retract, press the electrical tool pressure re-
lease button. If needed, move the head and repeat the procedure for
multiple crimps.
11. Inspect and test the connection in accordance with fitting supplier in-
structions, normal practice and applicable codes.
Electrical Connector lines
99 Washington Street
Melrose, MA 02176
Phone 781-665-1400
Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com
