Cleaning and Disinfecting the
Wet/Dry Vac
To keep your Wet/Dry Vac looking its
best, clean the outside with a cloth
dampened with warm water and mild
soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.
Before prolonged storage or as needed
(i.e., waste water pick up) the drum
should be disinfected.
To disinfect the drum:
1. Pour 2 liters of water and 10 mililiters
chlorine bleach into the drum.
2. Let solution stand for 20 minutes,
carefully swishing every few minutes,
making sure to wet all inside surfaces
of the drum.
3. Empty drum after 20 minutes. Rinse
with water until bleach smell is gone.
Allow drum to dry completely before
sealing the motor on the drum.
Filter Removal
Refer to page 29 "Filter Removal and
Installation" Section of this manual.
IMPORTANT:
To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the Vac for dry
material pickup.
Cleaning A Dry Filter
NOTE:
For best cleaning results due to
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
1. Light cleaning of some dry debris from
the filter can be accomplished without
removing the filter from the Vac. Simply
slap your hand on top of the handle
while the Vac is turned off.
2. Remove filter from Vac. Gently tap the
filter against the inside wall of your dust
drum and the debris will loosen and fall.
3. For thorough cleaning of a dry filter
with fine dust (no debris) you may run
water through it as described under
“Cleaning A Wet Filter” Section.
Maintenance (continued)
Cord Maintenance
When vacuuming is complete, unplug the
cord and wrap it around the motor cover.
If the power cord is damaged, it must be
replaced by the manufacturer or their
service agent or by similarly qualified
personnel to reduce the risk of accident.
Storage
Before storing your Vac, the drum should
be emptied and cleaned. The cord should
be wrapped around the unit and the hose
should be stored as described in this
manual. Accessories should be kept in
the same area as the Vac so they can be
readily available. The Vac should be
stored indoors.
Cleaning A Wet Filter
After filter is removed, run water through
the filter from a hose or spigot. Take care
that water pressure from the hose is not
strong enough to damage filter.
IMPORTANT:
After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can cause a lot of dust to come out
of your Vac. If your filter is damaged or
worn,
Replace it immediately
.
Installation
Refer to page 29 "Filter Removal and
Installation" Section of this manual.
Allow the filter to dry before reinstalling
and storing the Vac or picking up dry
debris.
33
SP6821 15 Litre WD4075BR0 4/16/12 1:49 PM Page 33
