Riello UPS CSS SENTINEL TOWER CAM 3, Installation And User Manual

- 19 - 

USE 

S

WITCHING ON FOR THE FIRST TIME

1)  Power on the CPS. 

2)  If there are Battery Cabinets, insert the fuse in the battery fuse holder isolator (SWBATT) 

3) 

Close the mains input switch (SWIN) in the back of the CPS. Close the fuse holder isolator (SWBATT) paying due 
attention  as  described  in  the  previous  chapter.  We  recommend  reading  the  paragraph  “

CPS – B

ATTERY 

C

ABINET

CONNECTION

” 

4)  After a few moments, the CPS will switch on, the display will light up, there will be a beep and the 

 icon will start to 

flash. The CPS is in stand-by mode: meaning that it is only consuming a small amount of power. The microcontroller 
supervising the self-diagnoses is powered; the batteries are charging; and everything is ready for CPS activation. 
Battery operation is also in stand-by mode provided that the timer is active. 

5)  Connect the equipment to the output of the CPS using cables no longer than 10 metres.   

WARNING:  Do  not  connect  the  EnergyShare  sockets  to  devices  that  absorb  more  than  10A.  For  equipment  that 
exceeds these levels, use the appropriate terminals only. 

6)  Check  which  operating  mode  is  set  on  the  display  and,  if  necessary,  see  the  “

C

ONFIGURING OPERATING MODES

” 

paragraph to set the required mode. For advanced configurations, set up the CPS with the appropriate configuration 
software.  

S

WITCHING ON FROM THE MAINS

1)  Press the “ON” button for 1 second. After pressing it, all the icons on the display light up for 1 second and the CPS 

beeps. 

2)  Close the output switch (SWOUT) in the back of the CPS. 

3)  Switch on the equipment connected to the CPS. 

When switching on for the first time only:

 after 30 seconds, check that the CPS is operating correctly: 

1)  Simulate a blackout by disconnecting power to the CPS. 

2)  The load must continue to be powered, the 

 icon on the display must light up and there must be a beep every 

4 seconds. 

3)  When power is reconnected, the CPS must go back to operating from the mains. 

S

WITCHING ON FROM THE BATTERY

1)  Hold down the “ON” button for at least 5 seconds. All the icons on the display light up for 1 second. 

2)  Switch on the equipment connected to the CPS. 

S

WITCHING OFF THE 

CPS 

In order to switch off the CPS, hold down the “STBY” button for at least 2 seconds. The CPS goes back to stand-by mode and 
the 

 icon starts to flash: 

1)  If the mains power is present, open the mains switch disconnector (SWIN) to completely turn off the CPS. 

2)  During battery mode operation with the timer not set, the CPS automatically switches off after 30 seconds. However, 

if  the  timer  is set,  press  and  hold  down  the  "STBY"  key  for  at least  5  seconds  to  turn  off  the  CPS. For  complete 
shutdown, open the mains switch disconnector (SWIN). 

I

NTERNAL CLOCK SETTING

During the first installation, you must set the internal CPS clock through the configuration software. If the CPS remains off or 
deactivated for more than 3 days, it will be necessary to re-configure the clock to avoid a failure of any programmed power-on 
or shut-down configuration.