Pag. 60 a 83
0MLMHTK65RUENUB
Basic menu (text lines area)
If no commands have been inserted, the first text line shows messages to inform about status of operation.
In each operating condition, the display returns to the "basic menu" after two minutes from the last
command inserted with the keys. The basic menu shows the signal messages relating to the current
operating state.
The first line of the basic menu shows:
When there are no alarms present the first text line of the main menu shows a fixed message,
“NORMAL
OPERATION”
When some alarms are present, the first text line of the main menu shows each active ALARM message,
“ALARM MESSAGES”,
one at a time for a few seconds:
The second line of the basic menu shows:
The second line displays the main operating values about system, output load, battery, buzzer and alarm message
number
The message U125A indicates an UPS model with 125kVA rated power, operating with 60Hz output frequency.
When the unit is set for the parallel operation the letter “P” is added (U125AP). The letter “P” became lower case
“p” when the unit operate as slave.
NORMAL OPERATION
U125A OUT=100%VA, BATT=100%Ah,
5=ON
Model UPS
Percent load connected to the output
State of battery charge
Audible alarm enabled/disabled
Rated power in kVA
NORMAL OPERATION
U125A OUT=100%VA, BATT=100%Ah, 5=ON
NORMAL OPERATION
U125A OUT=100%VA, BATT=100%Ah, 5=ON
First text line
ALARM MESSAGES
U125A OUT=100%VA, BATT=100%Ah, 5=ON
Second text line