page 12 / 84 0MLMHTM30RUENUA
3
Preliminary operations
3.1
Removing the packaging and positioning the unit
On delivery, the packaging must be inspected to ensure that it is whole and that it has not been crushed or
dented. Check in particular that neither of the two impact resistant devices on the packaging is red; if one of
them is red; follow the instructions on the packaging.
The essential details of the units are provided on the shipping document. The marking, weight and dimensions of
the various items making up the packing list are shown.
Check the state of the unit by means of a visual inspection of both the inside and the outside. Any dents seen
mean that it has suffered shocks during shipping, which could compromise the normal operation of the unit.
3.2
Storage
Place the unit in covered premises that are protected from direct contact with atmospheric agents and dust. The
following environmental values are those allowed in the storage area:
Temperature:
-13°F
to
+167°F (
-25 to + 75 °C)
Relative humidity:
30-95 % max.
For the installation of a battery cabinet, if provided with the uninterruptible power supply, follow the
instructions given in the specific manual.
The list of material provided may vary depending on the order specifications. As a general rule, the packaging
should include the following: this manual, the installation drawing, the warranty and eventual accessories.
3.3
Handling
The equipment must only be handled by adequately trained personnel. It can be unloaded from the vehicle and
put into place by lifting the box or the wooden deck to which the equipment is secured with a fork-lift truck. A
fork-lift truck should be used for the permanent positioning of the equipment, in accordance with the instructions
provided below.
1
Insert the forks of the fork-lift truck in the lower part of the device, from the front or back, and
ensure that they stick out about 12 inches on the other side.
2
Secure the unit to the fork-lift before moving it.
Risk of overturning
In order to avoid the risk of the unit overturning, ensure that the fork-lift truck has the appropriate size for
handling the weight of the unit and also that the unit is firmly secured to the fork-lift truck by means of
appropriate ropes before moving it.
When being moved the cabinet should be handled with care; shocks or drops can damage it. Once in position,
remove the packaging carefully in order not to scratch the unit.
The packaging should be removed as follows:
1.
Cut the bands
