14
I
NSTALLATION ENVIRONMENT
The UPS and the Battery Box must be installed in ventilated, clean environments which are sheltered from bad weather.
The relative humidity in the environment must not exceed the maximum values shown in the Technical Data table.
The ambient temperature, whilst the UPS is in operation, must remain between 0 and 40°C, and the UPS must not be positioned
in places which are exposed to direct sunlight or to hot air.
The recommended operating temperature for the UPS and the batteries is between 20 and 25°C. The actual
operating life of the batteries is 5 years on average with an operating temperature of 20°C. If the operating
temperature reaches 30°C, the operating life is halved.
This is a category C2 UPS product. In a residential environment, this product may cause radio interference, in
which case the user may be required to take additional measures.
For three-phase installation, this equipment complies with IEC 61000-3-12 provided that the short-circuit power
Ssc is greater than or equal to 2.94MW (7.4kA) at the interface point between the user's supply and the public
system. It is responsibility of the installer or the user to ensure that the equipment is connected to a supply with
the adequate short-circuit power Ssc (if required, consult the distribution network operator).
If the supply doesn’t meet the above requirements or if the requirements listed above are difficult to obtain, a
single-phase installation is suggested.
UPS
PLACEMENT
(
OR
B
ATTERY
B
OX
)
When installing the equipment, the following points should be considered:
the wheels are to be used exclusively for fine positioning, and thus for small distances only.
the plastic parts and the front panel are not to be used for gripping or pushing the UPS.
enough space should be left in front of the equipment for it to be turned on/off and maintenance operations to be
performed on it (1.5 m)
the rear part of the UPS should be set at least 30 cm from the wall, to enable the air blown by the ventilation fans to
flow away correctly
no objects should be left on its top surface
