20013749
4
GB
ELECTRICAL WIRING
NOTES:
– Do not exchange the neutral with the phase.
– Wires of min. 1 mm
2
section. (Unless requested otherwise by local
standards and legislation).
– The electrical wiring carried out by the installer must be in compliance
with the rules in force in the Country.
CONTROL BOX, (see fig. 4)
To remove the control box (1) from the burner:
®
Unscrew the fissing screws on the burner cover and remove it.
®
Unscrew the fissing screws (2) on the plate and remove the control
box (1).
®
Screw the two fissing screws (2) and reassemble the burner cover.
®
Fix the control box (1) with plate far from the burner.
TESTING
Check the shut-down of the burner by opening the thermostats.
Fig. 4
2
1
D4677
Key to lay-out
A
- Control box 530SE
C
- Capacitor
E
- Electrode
F
- Fuse
FR
- P.E. Cell
H
- Lock-out signal
I
- Main switch
M
- Motor
PE
- Burner-earth
TL
- Limit thermostat
TS
- Safety thermostat
XP.. - Pin plug
Y
- Oil valve
