‐
30
‐
INSERTION
1. If present, remove the protection cover and store it together with the fastening screws.
2. Check that the Switch Lock is in open position
(see picture on the right).
3. Carefully insert the BM in the cabinet (requires
two persons) and fasten it using the supplied
screws, as shown in the picture.
4. Turn the Switch Lock 90 degrees clockwise to the close position
(see picture on the right).
During the first start-up, the red alarm LED
will blink for 10 s, after which, if the
startup was successful, the green normal operation LED will switch on
.
Summary of Contents for multipower BTC 170
