‐
57
‐
C
OMMANDS
A
CCESS TO THE
C
OMMAND
P
ANEL
The “Power User” access level is required for accessing the Command Panel.
From this page it is possible to activate switch on/off commands for the system or for the individual module.
It is also possible to perform a Battery test and transfer the power cabinet to static bypass operation; the latter two actions are
available only at system level.
Operate the sliding switch to execute a command. The progress bar shows the progress of the start-up/shut-down sequence.
S
YSTEM
O
FF
/O
N COMMAND
Operate the sliding switch from O to I to switch the system on.
A confirmation of the action is requested for some of the commands.
Summary of Contents for multipower BTC 170
