Riello RS 120/E LN, Installation, Use And Maintenance Instructions

Installation

17 

20029324

4.1

Notes on safety for the installation

After carefully cleaning all around the area where the burner will
be installed, and arranging the correct lighting of the environ-
ment, proceed with the installation operations.

4.2

Handling 

The packaging of the burner includes a wooden platform, so it is
possible to move the burner (still packaged) with a transpallet
truck or fork lift truck.
With regard to the transport in the obligatory passages, refer to
the overall dimensions shown in Fig. 3, page 10.

Check also that the area in which you are working is empty and that
there is an adequate escape area (i.e. a free, safe area to which
you can quickly move if the burner should fall).
During the handling, keep the load at not more than 10” from the
ground.

4.3

Preliminary checks

Checking the consignment

4.4

Operation position

The burner is designed to operate only in the positions 

1

, 

2, 3

 and

4

 (Fig. 10).

Installation 

1

 is preferable, as it is the only one that allows the main-

tenance operations as described in this manual. Installations 

2

, 

3

and 4

 permit operation but make maintenance and inspection of

the combustion head more difficult.
Any other position could compromise the correct operation of the
appliance. 
Installation 

5

 is prohibited for safety reasons.

4

Installation

DANGER

All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.

WARNING

The installation of the burner must be carried out by
qualified personnel, as indicated in this manual and
in compliance with the standards and regulations of
the laws in force.

WARNING

The handling operations for the burner can be high-
ly dangerous if not carried out with the greatest at-
tention: keep any unauthorised people at a
distance; check the integrity and suitableness of the
available means of handling.

CAUTION

After positioning the burner near the installation
point, correctly dispose of all residual packaging,
separating the various types of material. 
Before proceeding with the installation operations,
carefully clean all around the area where the burner
will be installed.

CAUTION

After removing all the packaging, check the integrity
of the contents. In the event of doubt, do not use the
burner; contact the supplier.

The packaging elements (wooden cage or card-
board box, nails, clips, plastic bags, etc.) must not
be abandoned as they are potential sources of dan-
ger and pollution; they should be collected and dis-
posed of in the appropriate places.

WARNING

The output of the burner must be within the boiler's
firing rate;

WARNING

A burner label that has been tampered with, re-
moved or is missing, along with anything else that
prevents the definite identification of the burner
makes any installation or maintenance work diffi-
cult.

2

3

4

5

1

D7739

Fig. 10