14
R
ACK VERSION
The sequence of operations to be followed in order to transform the UPS or battery box into rack version are described
elow.
b
BEFORE CARRING OUT THE FOLLOWING SEQUENCE OF OPERATIONS, ENSURE THAT:
•
THE UPS IS COMPLETELY SWITCHED OFF AND NOT CONNECTED TO THE MAINS POWER
SUPPLY OR TO ANY LOAD.
•
THE BATTERY BOX IS DISCONNECTED FROM THE UPS, FROM ANY OTHER BATTERY BOXES
AND WITH THE BATTERY ISOLATOR OPEN
1 - Pick up the panel from the sides and gently pull it away from its position
just enough to be able to rotate it.
ATTENTION: The panel must be removed carefully
DO NOT ATTEMPT IN ANY WAY TO REMOVE THE PANEL FROM
THE UPS
2 - Rotate the panel 90° counter clockwise and reinsert it carefully into the
special housing.
3 - At this point, with the UPS or battery box in the horizontal position,
secure the handles using the screws provided, as shown in the figure.
NOTE:
Given the heavy weight, the use of support brackets is mandatory during rack installation (guide with L-shaped
support). For the same reason, it is recommended that the UPS and battery box be installed in the lower part
of the rack cabinet.
Summary of Contents for VSD 1100
Page 1: ......
Page 31: ...0MNVSD1K1RUENUA ...