19
REMOTE CONTROL TERMINAL BOARD
The remote control terminal allows for implementation of the REPO function (Remote Emergency Power Off) and to
remotely switch on/off the UPS.
The UPS is provided by the manufacturer with the REPO terminals short-circuited. For installation remove the short
circuit and connect to the device's normally closed contact.
In case of an emergency, if the stop device is used, the REPO control is opened and the UPS goes into stand-by mode
and the load is completely disconnected.
Attention:
before restarting the UPS, reset the stop device.
The circuitry of the remote control terminal board is self-powered with SELV circuits. Therefore, an external voltage
supply is not required. When a contact is closed, a maximum current of 15mA circulates.
All connections with the remote control terminal board are made through a cable which guarantees a double insulation
connection.
Logic of the connections:
•
PIN 1-2 REPO
The function is activated when the contact is opened.
•
PIN 2-3 REMOTE ON, REMOTE ON/OFF
The feature is activated by closing the contact.
Set by default as REMOTE ON, also configurable as REMOTE ON/OFF using
UPSTools
software.
Summary of Contents for VSD 1100
Page 1: ......
Page 31: ...0MNVSD1K1RUENUA ...