34
Laser Seam Tracking System for Welding Automation. RF627Weld Series
RF627Weld [Revision 1.1.1] 03.08.2020
The measurement of the point position on the line between other two points. This
position is defined by the "position" parameter, where "0" is the start of the line, and "1" is
the end of the line.
9. Endpoint shift in direction
The measurement of the endpoint shift (
D
) of the
LineTo
line relative to the endpoint
of the
LineFrom
line along the direction. The direction of shift is defined by the angle
(
Angle
), which is measured counterclockwise relative to the
LineReference
line and varies
in the range from 180° to 180°.
15.5.5. Built-in templates
The software offers two sets of built-in templates:
Measurement
and
Welding
.
By default, the software shows the
Measurement
set. To change a set, click on the
list of sets at the lower left corner of the window and select
Welding
.
Every template description contains a table with the following columns:
·
Constraints
- a list of constraints applied for this template (see p.
).
·
Measurements
- a list of measurements performed by this template (see p.
).
·
Parameters
- a list of search parameters applied for this template (see p.
).
15.5.5.1. "Measurement" set
15.5.5.1.1. Template 1 "Corner"
Template 1 consists of two lines and calculates the coordinates of the intersection
point of these lines.